Positive displacement flow meters measure the volumetric flow rate of a moving fluid or gas by way of precision-fitted gears or rotors containing cavities through which precisely known
volumes of fluid pass. A basic analogy would be holding a bucket below a tap, filling it to a set level, then quickly replacing it with another bucket and timing the rate at which the buckets
are filled (or the total number of buckets for the "totalized" flow).
Positive displacement flow meters are very accurate and have high turndown. They work best with clean, non-corrosive, and non-erosive liquids and gases, although some models will tolerate some
impurities. They require no straight runs of pipe for fluid flow stream conditioning though pressure drop can be an issue. They are widely used in custody transfer and are applied on residential
home natural gas and water metering.
There are two common types of positive displacement flow meters. Nutating disk meters feature a circular disk mounted on a ball inside a precision fitted measuring chamber. As the
liquid flows through the chamber, the disk rotates and wobbles upon the ball. Each rotation causes a predictable wobble which creates a cavity of a known size through which the liquid passes. By
using an indicator or totalizer, the number of rotations can be counted and the flow rate determined.
Oval gear meters use oval shaped gear-toothed rotors that rotate within a chamber. As these rotors turn, they sweep out and trap a very precise volume of fluid between the outer oval
shape of the gears and the inner chamber walls. The flow rate is then calculated based on the number of times these compartments are filled and emptied.
Selecting a Flow Meter
The basis of good flow meter selection is a clear understanding of the requirements of the particular application. Therefore, time should be invested in fully evaluating the nature of the process
fluid and of the overall installation.
- What is the fluid being measured by the flow meter(s) (air, water, etc…)?
- Do you require rate measurement and/or totalization from the flow meter?
- If the liquid is not water, what viscosity is the liquid?
- Is the fluid clean?
- Do you require a local display on the flow meter or do you need an electronic signal output?
- What is the minimum and maximum flow rate for the flow meter?
- What is the minimum and maximum process pressure?
- What is the minimum and maximum process temperature?
- Is the fluid chemically compatible with the flow meter wetted parts?
- If this is a process application, what is the size of the pipe?
If you have any questions or need any help selecting a flow meter, please contact us at sales@instrumart.com or 1-800-884-4967 to speak with an applications engineer.
